Table of Contents
Advertisement
Chapter 12: Emulator/Analyzer Interface Commands
load
The parameters are as follows:
configuration
This option specifies that a previously created emulation configuration file will be
loaded into the emulator. You can follow this option with a file name. Otherwise
the previously loaded configuration will be reloaded.
emul_mem
Loads only those portions of the absolute file that reside in memory ranges mapped
as emulation memory.
<FILE>
This represents the absolute file to be loaded into either target system memory,
emulation memory (.X files are assumed), or the trace memory (.TR files are
assumed).
noabort
This option allows you to load a file even if part of the file is located at memory
mapped as "guarded" or "target ROM" (trom).
nosymbols
This option causes the file specified to be loaded without symbols.
noupdate
This option suppresses rebuilding of the symbol data base when you load an
absolute file. If you load an absolute file, end emulation, then modify the file (and
relink it), the symbol database will not be updated upon reentering emulation and
reloading the file. The default is to rebuild the database.
symbols
This option causes the file specified to be loaded with symbols.
trace
This option allows you to load a previously generated trace file.
trace_spec
This option allows you to load a previously generated trace specification.
Note that the current trace specification will be modified, but a new trace will not
be started. To start a trace with the newly loaded trace specification, enter trace
again or specify trace again (not trace). If you specify trace, a new trace will
begin with the default trace specification, not the one you loaded.
user_mem
Loads only those portions of the absolute file that reside in memory ranges mapped
as target memory.
Examples
load sort1 <RETURN>
load configuration config3 <RETURN>
See Also
The display trace command.
422
Advertisement
Table of Contents
