HP 64746 User Manual page 514

Chapter 13: Error Messages
Terminal Interface Messages
613 Analyzer Break
Cause: Status message.
614 Guarded memory access break
Cause: This message is displayed if the emulation processor attempts to read or
write memory mapped as guarded.
Action: Troubleshoot your program; or, you may have mapped memory incorrectly.
615
Software breakpoint: %s
Cause: This status message will be displayed if a software breakpoint is
encountered during a program run. The emulator is broken to the monitor. The
string %s indicates the address where the breakpoint was encountered.
616
BNC trigger break
Cause: This status message will be displayed if you have configured the emulator
to break on a BNC trigger signal and the BNC trigger line is activated during a
program run. The emulator is broken to the monitor.
617 CMB trigger break
Cause: This status message will be displayed if you have configured the emulator
to break on a CMB trigger signal and the CMB trigger line is activated during a
program run. The emulator is broken to the monitor.
618 trig1 break
Cause: This status message will be displayed if you use the break_on_trigger
syntax of the trace command and the analyzer has found the trigger condition while
tracing a program run. The emulator is broken to the monitor.
619
trig2 break
Cause: This status message will be displayed if you have used the internal trig2
line to connect the analyzer or external analyzer trigger output to the emulator
break input and the analyzer has found the trigger condition. The emulator is
broken to the monitor.
514