Table of Contents
Advertisement
Chapter 16: Installation
Step 1. Install Boards into the HP 64700 Card Cage
11 If you installed the HP 64703A analyzer card, install the right angle adapter board by turning the
thumb screws clockwise.
Connect the external analyzer probe cable to the right angle adapter board. Each connector of the
external analyzer cable is keyed so that it can be connected to the right angle adapter board in only one
way. Check for bent connector pins before connecting the analyzer probe cable. Align the key of the
external analyzer cable connector with the slot in the right angle adapter board, and gently press the
external analyzer cable connector into the connector on the right angle adapter board. Position the cable
as shown below.
562
Advertisement
Table of Contents
