Table C-1. Configuring Dial-In Ports/Quick2Config Annex; Table C-2. Configuring Dial-In Ports Using Annex Manager - Bay Networks Baystream 7 Configuration And Troubleshooting Manual

Configuring and Troubleshooting Bay Dial VPN Services
Table C-1.
Select This
Window or Tab
General Port tab
Interfaces Port tab
Table C-2.
In This Window
General Setup
Security Setup
Async Ports Setup Select all ports on the window.
Edit Async Ports
Interfaces Port tab Enter the subnet mask.
C-3
Configuring Dial-In Ports/Quick2Config Annex
Action
Set the modem type.
Set the Direction and Mode.
Set the subnet mask.
To accept these settings, click on Apply.
Table C-2 summarizes how to configure the dial-in ports on the Remote
Annex using Annex Manager, after first selecting the Annex from the list.
Configuring Dial-In Ports Using Annex Manager
Action
Click on More.
Set Security Preferred Host.
Click on OK to accept these
settings.
Enable security for the following
parameters:
Incoming Ports with Modems
Incoming Ports without Modems
Set PPP Security Protocol.
Set the modem type.
Set the direction and mode.
BayStream Multiservice Software Version 7.2
(continued)
Value/Result
Select the appropriate modem
type from the list. This
automatically sets the flow
control and control lines.
Set Direction to Incoming and
Mode to AutoDetect.
Any valid subnet mask
Value/Result
Not applicable
IP address of the preferred
security host
Not applicable
Click on the appropriate boxes to
enable security. This
automatically sets the
enable_security parameter to y.
CHAP or PAP
Displays the Edit Async Ports
window.
Select the appropriate modem
type from the list. This
automatically sets the flow control
and control lines.
Set Direction to Incoming and
Mode to AutoDetect.
Any valid subnet mask
115623B Rev. 00