Bay Networks Baystream 7 Configuration And Troubleshooting Manual page 75

Table 5-2. tms_dbm Command Arguments
Argument
maxu= {max_users | unlimited}
hwtype= hw_type
hwaddr= hw_addr
hwalen= hw_addr_len
115623B Rev. 00
Function
Specifies the maximum number of
concurrent users allowed on the system.
A value of unlimited means that any
number of concurrent users are allowed.
A value of 0 indicates that no users are
allowed on the system.
For the modify command, you can use
this value to make a domain quiet and
keep it disabled without deleting it. If you
reset the maxu parameter to a value
below the current number of users,
additional (new) users must wait until
the count drops below the new
maximum. Excess users, however, are
not arbitrarily dropped.
hwtype indicates the type of network
connection between the gateway and
the CPE router. For Dial VPN, hwtype
must be fr (for frame relay). If not
specified, the gateway is the CPE router.
hwaddr is a link address associated
with the network. If hwalen is four bytes
or less, you can specify this as a
decimal number. TMS converts it to a
hexadecimal number. To specify this
value as a hexadecimal number, prefix
the number with 0x. For a frame relay
connection, this argument is required; it
specifies the DLCI.
hwalen is an optional parameter that
specifies the length in octets of the
address. If you omit this parameter, TMS
calculates its value based on the value
of the hwaddr parameter. For example,
if hwaddr is less than 256, hwalen will
be 1 byte. If hwaddr is 400, hwalen is 2
bytes. Unless the actual hwaddr length
requires it, you should accept the default
length, 1 byte.
BayStream Multiservice Software Version 7.2
Configuring TMS for an erpcd-based Network
(continued)
Used with These
Commands
Required for add and
modify. Not used for other
commands.
All parts of this argument
are required for add and
modify, since this is a
frame relay connection.
Not used for other
commands.
(continued)
5-7