Bay Networks Baystream 7 Configuration And Troubleshooting Manual page 140

Configuring and Troubleshooting Bay Dial VPN Services
Table 11-2. Remote Annex Troubleshooting Chart
Problem/Symptom
Annex does not advertise
updates.
11-20
Possible Cause
1. Is the Annex parameter
N
to ?
2. Did you reboot the Annex after
routed
setting ?
3. Is the Annex parameter
option_key
set to allow active RIP,
and did you reboot the Annex after
option_key
setting
stats –o
command
active RIP is enabled.
If the display shows RIP as enabled,
something else is preventing the Annex
from sending updates.
4. Is the Annex broadcast address set
correctly?
5. Are at least two interfaces up and
running?
BayStream Multiservice Software Version 7.2
(continued)
Action
routed
set Use the following CLI commands to
obtain information about IP routing on
your network.
• To display the contents of the
Annex routing table, use
netstat –r
• To display the contents of the
? Issue the CLI routing cache (containing
to verify that user-configured routes), use
netstat –C.
1. Verify that the Annex
parameter is set to
2. If necessary, reboot the Annex.
3. See the description of enabling and
disabling active RIP in the Remote
Annex Administrator's Guide for
UNIX .
Use the
the status of the options.
annex
KEYED OPTIONS:
LAT: keyed off
Atalk: keyed off
tn3270: keyed off
dialout/RIP/filtering: keyed on
IPX: keyed off
MODULES DISABLED None
The MODULES DISABLED field indicates
the current setting of the
disabled_modules
dialout appears here as disabled, you
cannot use dialout, RIP, or filtering,
even if they are keyed on.
Verify the Annex broadcast address.
Verify that at least two interfaces are up
and running.
.
routed
Y
.
stats -o
command to display
stats –o
:
parameter. If a
(continued)
115623B Rev. 00