Bay Networks Baystream 7 Configuration And Troubleshooting Manual page 61

115623B Rev. 00
show port ppp
To change a particular setting, enter the
parameters you want to change.
The settings relevant to Dial VPN are:
set port slip_ppp_sec y
set port ppp_sec_prot <chap or pap>
set port address_origin auth_server
The
slip_ppp_security
or RADIUS for PPP and protocol security. The
specifies the local authentication protocol; in this case, CHAP. A client dialing
in has to get a remote IP address. For Dial VPN, the
must be set to
auth_server
BaySecure Access Control Administration Guide.
For information on the settings of the remaining port parameters, refer to:
• Remote Annex Administrator's Guide for UNIX
• Remote Annex 6300 Supplement to the Remote Annex Administrator's
Guide for UNIX
• Managing Remote Access Concentrators Using Command Line
Interfaces.
Set the primary preferred security host to the address of the primary TMS
server. You can also designate the secondary TMS server (if any) as the
secondary preferred security host. Accept the default value if the optional
secondary security host is not in use.
Enable security on the Annex, but disable the security broadcast feature.
Setting the security broadcast parameter to N ensures that the security
information comes from one of the defined TMS servers.
For all Remote Annex models, the mode on the dial-in port can be set to
or auto_detect . For Remote Annex models 6100/5391and 6300/5393, and for
Remote Access Concentrator 8000/5399, enter the following configuration
command sequence from the
set annex enable_security y
set annex pref_secure1_host <ip address of TMS host - ACP or BSAC>
set annex pref_secure2_host <ip address of secondary security host>
set annex security_broadcast N
set annex auth_protocol <acp or Radius>
BayStream Multiservice Software Version 7.2
set port
parameter controls dial-in PPP access and use of ACP
. For information on BSAC security, refer to the
or prompt:
na admin
Configuring the Remote Annex
command along with the
parameter
ppp_sec_protocol
address_origin
parameter
PPP
4-3