Bay Networks Baystream 7 Configuration And Troubleshooting Manual page 131

4.
115623B Rev. 00
• Quick Get - Lets you click your way down the MIB tree to a MIB
attribute and retrieve and display its values.
• Screen Manager - Lets you select windows of statistics from the Default
Screens window, which contains a list of statistics windows provided with
Site Manager. You can either add the selected windows to the Current
Screens List window so you can open these windows or copy them to the
User Screens window so you can customize them.
• Launch Facility - Lets you select and display the values for one of the
statistics windows you added to the Current Screens List.
• Screen Builder - Lets you build windows of statistics from scratch or
customize statistics windows you copied to the User Screens window.
Refer to the BayStream manual, Statistics, for detailed instructions on using
the Statistics Manager.
Display the tunnel statistics by using the
At the Remote Annex console, enter the command
status of the current Dial VPN tunnels. This command displays the following
information:
• Device ( ) - The destination port on which the tunnel terminates. This
Dev
can be any valid asynchronous port numbers; for example, asy2 for port 2.
• Protocol ( ) - The connection protocol.
Proto
• Connection state (
registering, established, or de-registering.
• The time (When) of the last connection state change.
• Remote node address (
assigned to the remote node. The value at the end of the "Home Address"
indicates the subnet mask of the dial-in client. This form of display is
similar to the display of the route table in the annex "netstat -r".
• Home agent address (
resides on the gateway.
• WAN type to home network (
the home agent on the gateway to the CPE on the destination network. For
this release of Dial VPN, the only valid value is FR (for frame relay).
BayStream Multiservice Software Version 7.2
State ) - The state of the tunnel. Possible values are
home address ) - The protocol-specific address
ha address ) - The IP address of the home agent that
wan ) - The WAN type of the interface from
Troubleshooting
command.
netstat -T
to review the
netstat -T
11-11