Bay Networks Baystream 7 Configuration And Troubleshooting Manual page 150

Configuring and Troubleshooting Bay Dial VPN Services
Table A-1. Network Information Worksheet
Requested Information
Default volume where TFTP transactions will take place.
Example: 2
Enable FTP?
Example: Yes
Default volume where FTP transactions will take place.
Example: 2
Enable TELNET?
Example: No
Site Manager Workstation Information
IP address of the workstation on which the Site Manager software will be
installed. This information is requested when the installation is tested at the
end of the procedure.
Example: 192.32.10.12
WAN Information
The following information about enabling frame relay, PPP, and SMDS from the installation script is for
experienced users only. Normally these protocols are implemented from Site Manager on an additional
interface.
Frame Relay Information
(To enable frame relay on a synchronous connector on this initial IP interface)
Enable frame relay on the interface?
Example: Yes
Management protocol that communicates with the frame relay network.
Example: LMI
DLCI addressing types.
Example: ADDR Q.922
Frame relay address field length.
Example: 2 bytes
Frame relay PVC ID.
Example: 30
A-4 BayStream Multiservice Software Version 7.2
(continued)
Your Information
(continued)
115623B Rev. 00