Table C-4. Enabling System Logging - Bay Networks Baystream 7 Configuration And Troubleshooting Manual

Configuring and Troubleshooting Bay Dial VPN Services
Table C-4.
Interface
Quick2Config Annex 1. Select the General Annex tab.
Annex Manager
6.
C-5
Enabling System Logging
Actions
2. Select All from the Logging menu.
3. Display the Advanced Annex tab.
4. In the Logging Host field, enter the IP address of the host to
maintain the system log.
5. Click on Apply to accept these changes.
1. Display the General Setup window
2. Select All from the Logging menu.
3. Click on More to display the General Setup (continued) window.
4. Enter the IP address of the host to maintain the system log.
5. Click on Apply to accept these changes.
For logging to work, you should enable erpcd syslogging and create the
appropriate log files on the host, and then restart the syslog daemon. For
information on these functions, refer to the Remote Annex System
Administrator's Guide for UNIX, the Remote Annex 6300 Supplement to the
Remote Annex System Administrator's Guide for UNIX, or Managing Remote
Access Concentrators Using Command Line Interfaces. For instructions on
how to perform these tasks for applications running under UNIX, refer to your
UNIX system documentation. The erpcd utility uses the auth facility.
Reboot the Remote Annex.
To reboot the Annex, using either Quick2Config Annex or Annex Manager:
From the Configure menu, select the Boot option.
a.
Click on Apply.
b.
BayStream Multiservice Software Version 7.2 115623B Rev. 00