Bay Networks Baystream 7 Configuration And Troubleshooting Manual page 71

Configuring TMS for an erpcd-based Network
[srvloc=servers_location] [tutype=tunnel_type]\
pauth=<ip addr of primary authentication server>\
sauth=<ip addr of secondary authentication server>\
[pacct=<ip addr of primary accounting server>\
[sacct=<ip addr of secondary accounting server>]]\
[paddr=<ip addr of primary dynamic address server>\
[saddr=<ip addr of secondary dynamic address server>]]\
authp=<radius or acp> [acctp=accounting protocol] \
[addrp=dynamic address allocation protocol]\
[spi=<security protocol index>] [passw=password] [tatype=kmd5-128
tamode=pref-suff takey=<authentication key value (in hex, 256 bits)>]
Note: In this syntax description, square brackets [ ] indicate optional
parameters.
The dialed number parameter is available only for 6300/5393 and 8000/5399
dnis
products. By default, is set to 0 for all Remote Annexes and Remote Access
dnis
Concentrators.
The parameter is optional. If you do specify the parameter, use the
hwalen hwalen
actual length in bytes of the hexadecimal value of the DLCI number (the hardware
address). For example, if the DLCI is 101 (that is, 0x65), the hardware address
length is 1 byte. For a hardware address of 400 (0x190), the hardware address
length is 2 bytes.
If you omit the hwalen parameter, tms_dbm derives the length from the value of
the hwaddr parameter. If, for the hwaddr parameter, you specify a decimal value
31
that is smaller than 4 bytes (that is, from 0 through 2 ), TMS converts that value
to hexadecimal. To specify a hexadecimal value, prefix the number with the
characters 0x; for example, to express 64 (decimal), specify 0x40.
Note: The ha (home agent) parameter used in previous versions is still
recognized, but the te (tunnel endpoint) parameter required in the current
version has taken over its function.
Table 5-1 lists the tunnel management ( tms_dbm ) commands, and Table 5-2 lists
the options/ranges for each of the TMS command elements.
115623B Rev. 00 BayStream Multiservice Software Version 7.2 5-3