Installing And Configuring The Annex Software - Bay Networks Baystream 7 Configuration And Troubleshooting Manual

Configuring and Troubleshooting Bay Dial VPN Services
Installing and Configuring the Annex Software
This section is an overview of the installation and configuration process,
highlighting areas of particular concern. Subsequent sections describe the process
in more detail and include more extensive examples.
Note: To facilitate troubleshooting, test each element of your system after you
configure it and before proceeding to the next phase of the configuration.
1.
2.
3.
4-2
Install the Annex Software.
This is a standard installation using the installation script supplied for Dial
VPN, as described in the documentation for the particular device you are
installing.
As part of the hardware installation, you may have issued ROM Monitor
commands through a terminal connected to the console port located on the
Remote Annex. These commands let you set a subset of the configuration
(EEPROM) parameters, including the unit's IP address, required for booting
the Remote Annex.
You can also specify parameter values that are required if the network
configuration differs from the default values. Refer to the hardware
installation guides for the Remote Annex or Remote Access Concentrator
being installed for the list of the ROM Monitor commands and their default
values.
Boot the Annex software (standard installation).
The Annex (used generically here to indicate either the Remote Annex or the
Remote Access Concentrator) gets its operational code by downloading it
over the network from (among other sources) a UNIX host that runs Annex
file server software. The Annex boots each time it is powered up and
whenever it receives a
image by setting the preferred load host.
Set up the dial-in port on the Annex for dial-in, and enable ACP or
RADIUS (BSAC) security for PPP on all ports.
Configure security on the Annex using either ACP (for an erpcd-based
network) or BSAC (for a RADIUS-only network) configure the dial-in ports.
To display the current port settings, enter:
BayStream Multiservice Software Version 7.2
boot command. You specify the source of the boot
115623B Rev. 00