Configuring Ipx On The Cpe Router With Site Manager - Bay Networks Baystream 7 Configuration And Troubleshooting Manual

To enable IPX, you must enter this software option key, then reboot the NAS to
activate the newly entered key. Software option keys cannot be activated with the
reset
The annex
one screen. Make sure that the
The following example shows the output of this command, with the
parameter value highlighted.
admin: show port ppp
global port:
slip_ppp_security:
net_inactivity_units:
ppp_security_protocol:
ppp_password_remote:
mp_endpoint_class:
Configuring IPX on the CPE router with Site Manager
You must also configure IPX on the CPE router on the home network. The
following steps describe how to use Site Manager to configure IPX on a Bay
Networks CPE router. If the CPE router is not a Bay Networks device, refer to the
manufacturer's configuration instructions.
1.
2.
115623B Rev. 00
command.
show port ppp
local address:
do_compression:
ppp_mru:
ppp_sec_auto:
From the Site Manager window, use the Tools menu to select
Configuration Manager in dynamic mode.
The path is Site Manager > Tools > Configuration Manager > Dynamic.
Click the interface on which you want to add the IPX information.
The Edit Connector window appears.
BayStream Multiservice Software Version 7.2
Configuring IPX as the Routing Protocol
command shows several configuration parameters on
parameter is set to
ppp_ncp
132.245.54.54
Y
N
minutes
1500
pap
"<unset>"
N
mac
or
all IPCP and IPXCP
ppp_ncp
metric:
net_inactivity:
allow_compression:
address origin:
ppp_acm:
ppp_username_remote:
ppp_ncp:
mp_mrru:
mp_endpoint_addresss:
.
1
off
N
acp
0x0
""
all
1500
8-5