Figure 3-5. Quick2Config Annex Reset Confirmation Dialog Box - Bay Networks NA Install Manual

4. Click on Incoming in the Direction box and AutoDetect in the
Mode box if these settings have not already been chosen.
5. Click on Apply.
Quick2Config Annex opens a dialog box for you to confirm that Port 1
is to be reset (Figure
Figure 3-5. Quick2Config Annex Reset Confirmation Dialog Box
6. Click on OK.
7. Click on the Line Control tab.
Quick2Config Annex displays the tab for setting flow control and
modem speed
8. Deselect Use Modem Signals (DTR/DCD/DSR) for Flow Control in
the Flow Control box.
9. Click on Software (XON/XOFF) in the Flow Control box.
10. Set the Serial Port Speed to the appropriate speed.
The settings are shown in
Installing Remote Annex Network Software for Windows
Chapter 3
3-5).
(Figure 3-6).
Figure 3-6.
Configuration Examples
3-5