Configuring The Remote Annex; Table 4-1. Where To Find Configuration Information - Bay Networks Baystream 7 Configuration And Troubleshooting Manual

This chapter describes how to use the command line interface (CLI) commands to
configure a Remote Annex or Remote Access Concentrator device as a network
access server for Dial VPN. This should get your NAS up and running, but for
details regarding your specific device, refer to the documentation for the particular
model you are configuring, as shown in
Table 4-1.
For information on
Using the Annex Manager to configure the
Remote Annex
Using the Annex Manager with Remote
Access Concentrators
Remote Annex configuration and
administration procedures, and a detailed
description of all na and admin commands
and parameters
Remote Access Concentrator configuration
and administration procedures
You configure the Remote Annex or Remote Access Concentrator by attaching a
PC in terminal emulation mode or an ASCII terminal to the console port of the
device.
115623B Rev. 00
Configuring the Remote Annex
Where to Find Configuration Information
BayStream Multiservice Software Version 7.2
Table 4-1.
Refer to this document
Appendix C, "Using Quick2Config and
Annex Manager."
Managing Remote Access Concentrators
Using Annex Manager.
• Remote Annex Administrator's Guide for
UNIX
• Remote Annex 6300 Supplement to the
Remote Annex Administrator's Guide for
UNIX
• Quick Start Guide for Remote Access
Concentrators
• Managing Remote Access
Concentrators Using Command Line
Interfaces
• Managing Remote Access
Concentrators Using Annex Manager
Chapter 4
4-1