Removing A Dimm - Huawei RH2288H V3 User Manual

RH2288H V3 Server
User Guide
Figure 7-88 Installing a heat sink
Step 17 Use a Phillips screwdriver to tighten the four screws on the heat sink in the
diagonal direction. See (2) in
Step 18 Install the air duct. For details, see
Step 19 Install full-height full-length riser cards if they are required. For details, see
Installing a Riser
Step 20 Install the chassis cover. For details, see
Step 21 Install the RH2288H V3. For details, see
Step 22 Connect all external cables such as power and network cables. For details, see
Connecting External
Step 23 Power on the RH2288H V3. For details, see
----End

7.41 Removing a DIMM

Remove a DIMM if it has failed or needs to be replaced with a new model.
Procedure
Step 1 Wear an ESD wrist strap. For details, see
Step 2 Determine the cabinet number and chassis number of the server, and label its
panel to prevent misoperations.
Step 3 Power off the RH2288H V3. For details, see
Issue 46 (2022-12-28)
Figure
Card.
Cables.
Copyright © Huawei Technologies Co., Ltd.
7-88.
7.14 Installing the Air
7.12 Installing the Chassis
3.4 Installing the
4.1 Powering On the
1 Safety Instructions.
4.2 Powering Off the
7 Replacing Parts
Duct.
7.20
Cover.
Server.
3.5
Server.
Server.
226