Huawei RH2288H V3 User Manual page 139

RH2288H V3 Server
User Guide
●
Issue 46 (2022-12-28)
Figure 5-4 Querying the health status for the RH2288H V3
d. Clear alarms. For details, see
Handling
.
NO TE
If the query result in
this step.
Check the RH2288H V3 using the iBMC CLI.
a. Log in to the iBMC CLI.
i. Set an IP address for the PC, and ensure that the IP address is on the
same network segment as the iBMC management network port.
ii. Connect the PC to the RH2288H V3 iBMC management network port
by using a network cable.
iii. Run a command line management tool (such as SSH and PuTTY)
tool on the PC, and enter the IP address of the iBMC management
network port, user name, and password to log in.
NO TE
By default, SSH is used to log in to iBMC. If the SSH service is disabled,
enable it by choosing Config > Service Settings on the iBMC WebUI.
b. View the RH2288H V3 version information.
Check that the RH2288H V3 versions meet site requirements.
Hi1710 / # ipmcget -d v
------------------- iBMC INFO -------------------
IPMC CPU:
IPMI Version:
CPLD Version:
Active iBMC Version:
Active iBMC Built:
Backup iBMC Version:
SDK Version:
SDK Built:
Active Uboot Version:
Backup Uboot Version:
----------------- Product INFO -----------------
Product ID:
Product Name:
Product Version:
BIOS Version:
-------------- Mother Board INFO ---------------
Copyright © Huawei Technologies Co., Ltd.
Huawei Rack Server iBMC Alarm
c indicates that no alarm is generated for the server, skip
Hi1710
2.0
(U46)1.05
(U25)1.26
08:26:05 Dec 23 2014
1.26
1.47
08:28:02 Dec 19 2014
1.1.29 (Oct 13 2014 - 15:23:00)
1.1.29 (Oct 13 2014 - 15:23:00)
0x0001
RH2288H
V3
(U47)1.19
5 Configuring the RH2288H V3
126