Removing The Server; Removing The Server And L-Shaped Guide Rails - Huawei RH2288H V3 User Manual

RH2288H V3 Server
User Guide
Table 3-3
Table 3-3 Cable connection checklist
Item
Power cable
Network cable
Ground cable

3.6 Removing the Server

3.6.1 Removing the Server and L-Shaped Guide Rails

Step 1 Wear an ESD wrist strap or ESD gloves. For details, see
Step 2 Power off the server. For details, see
Step 3 Disconnect all power cables and signal cables from the server.
Step 4 Remove the server.
1.
Issue 46 (2022-12-28)
lists the cable connection check items.
Description
The power cable is connected correctly to the rear of the
chassis.
Network cables are connected correctly to the management
Ethernet ports or service Ethernet ports on the rear panel of
the chassis.
The RH2288H V3 server does not provide a separate ground
port. It is grounded through the ground cable of a power
cable. Ensure that the power cables of the PSUs are in good
contact.
NO TE
Remove power cables first to prevent damage or injury caused by static electricity.
Loosen the captive screws on the RH2288H V3 panel using a screwdriver. See
(1) in Figure 3-27.
Copyright © Huawei Technologies Co., Ltd.
3 Installing and Removing the RH2288H V3
1 Safety
4 Powering On and Off the
Instructions.
Server.
108