Table of Contents
Advertisement
FusionServer Pro XH321 V5 Server Node
Maintenance and Service Guide
●
●
8.3.3 Removing an XH321 V5
Procedure
Step 1 Determine the position of the server node in the chassis.
Figure 8-2 Positions and slot numbers of the XH321 V5 server nodes
Step 2 Power off the server node.
For details, see
Step 3 Remove the multi-port cable.
1.
2.
Issue 17 (2021-03-09)
a.
Log in to the iBMC WebUI.
For details, see
10.2 Logging In to the iBMC
b.
Choose Power > Power Control.
The Power Control page is displayed.
c.
Click Power Off or Forced Power Off.
A confirmation message is displayed.
d.
Click OK.
The server starts to be powered off.
Use the iBMC CLI.
a.
Log in to the iBMC CLI.
For details, see
10.4 Logging In to the
b.
Run the following command:
ipmcset -d powerstate -v 1
c.
Type y or Y and press Enter.
Use the Remote Virtual Console.
a.
Log in to the Remote Virtual Console.
For details, see
10.3 Logging In to the Desktop of a
b.
On the KVM screen, click
c.
Choose Power Off or Forced Power Off.
A dialog box is displayed.
d.
Click Yes.
8.3.2 Power-Off
Press the two tabs on the multi-port cable connector. See (1) in
Remove the multi-port cable from the universal connector port (UCP) on the
server. See (2) in
Figure
Copyright © Huawei Technologies Co., Ltd.
CLI.
or
on the toolbar.
Procedure.
8-3.
8 Parts Replacement
WebUI.
Server.
Figure
8-3.
44
Advertisement
Table of Contents
