Removing An Nvme Pcie Ssd; Installing An Nvme Pcie Ssd; Removing A Psu; Removing An Ac Psu - Huawei RH2288H V3 User Manual

RH2288H V3 Server
User Guide
Figure 7-9 Installing a drive
Step 5 Ensure that the ejector lever is fastened to the chassis beam, and then close it to
completely insert the drive into the slot. See (2) in
Observe the drive indicators to check the drive operating status. For details about
the indicators, see
Step 6 If the server is equipped with a front bezel, install the bezel after installing the
front drive. For details, see
Step 7 After verifying drive status, configure RAID properties based on actual service
requirements. For details, see
User Guide
----End

7.7 Removing an NVMe PCIe SSD

For details, see "Removing an ES3000 V3" in
Guide

7.8 Installing an NVMe PCIe SSD

For details, see "Installing ES3000 V3" in

7.9 Removing a PSU

7.9.1 Removing an AC PSU

Remove an AC PSU before replacing it with a new one.
When two PSUs are configured, remove one PSU without powering off the
RH2288H V3 if the other PSU is operating properly and its power rating is greater
than or equal to the power rating of the RH2288H V3.
Issue 46 (2022-12-28)
2.4 Indicators and
.
.
Copyright © Huawei Technologies Co., Ltd.
Buttons.
7.4 (Optional) Installing the Front
Huawei V2 and V3 Server RAID Controller Card
ES3000 V3 NVMe PCIe SSD User
ES3000 V3 NVMe PCIe SSD User Guide
7 Replacing Parts
Figure 7-9.
Bezel.
.
157