Table of Contents
Advertisement
FUEL SYSTEM (Proarammed Fuel Iniection)
MIL 8 BLINKS (TP SENSOR)
1. Recheck MIL
Erase the self-diagnostic memory to reset the
ECM (page 5-8).
Start the engine and let
it
idle. Check that the
MIL blinks.
Is the MIL blinking?
NO
-
Temporarily failure; the system is nor-
mal.
YES
-
Replace the throttle body/ECM assem-
bly with a new one, and inspect again.
M I L
9 BLINKS
(IAT SENSOR)
1. Recheck MIL
Erase the self-diagnostic memory to reset the
ECM (page 5-8).
Start the engine and let
it
idle. Check that the
MIL blinks.
Is the
MIL
blinking?
NO
YES
-
Temporarily failure; the system is nor-
mal.
-
Replace the throttle body/ECM assem-
bly with a new one, and inspect again.
MIL 12 BLINKS (FUEL INJECTOR)
NOTE:
.
Before starting the troubleshooting, check the
injector 2P connector for loose contacts or cor-
roded terminals, and recheck the MIL.
1. Injector Resistance Inspection
Remove the luggage box (page 2-5).
Turn the ignition switch to
OFF.
Disconnect the injector 2P connector.
Measure the resistance between the injector ter-
minals.
Standard: 11.1
-
12.3 ! 2
(20°C/68"F)
Is
the resistance within 11.1
-
12.3
R
/20"c/
68
OF)?
NO
-
Faulty injector.
YES
- GO
TO STEP 2.
5-1
3
Advertisement
Chapters
Table of Contents
