Honda SH125 Manual page 118

FUEL SYSTEM (Programmed Fuel Injection)
The throttle body/ECM assembly is factory pre-
set. Do not disassemble it. Loosening the white
painted fasteners can cause throttle body/ECM
malfunction.
INSTALLATION
NOTE:
Route the hoses and cable properly (page 1-17).
The insulator is
Install the insulator onto the throttle body by align-
installed with the
ing the groove with the lug.
"THROT BODY"
side facing the
throttle body.
Install the insulator band over the insulator by align-
ing the hole with the locating pin of the insulator.
Install the band bolts and collars (between the band
ends). Install the plate nuts and tighten the bolts
loosely.
Install the connecting tube and tighten the band
screw in the direction as shown.
I
TUBE
5-39