Honda SH125 Manual page 270

FRONT WHEEL/SUSPENSION/STEERlNG
Be careful not to
cross-thread the
adjuster.
Align the edge of
the master cylinder
with the punch
mark on the handle-
bar.
Install the joint cable into the cable holder on the
master cylinder and screw the adjuster fully.
Install the brake master cylinder and holder with the
"UP" mark facing up.
Tighten the upper bolt first, then tighten the lower
bolt.
TORQUE: 12 N.m (1.2 kgf-m, 9 Ibf.ft)
Install the setting spring into the cable holder and
connect the cable to the cable joint.
Adjust the rear brake lever and joint cable free play
(page 3-16).
Install the combination meter (page 20-8).
STEERING STEM
REMOVAL
NOTE:
Always replace the bearings and races as a set.
Remove the following:
-
handlebar (page 14-19)
-
fork legs (page 14-12)
Remove the bolt and brake hose clamp.
Loosen the stem lock nut while holding the upper
inner race.
TOOLS:
Socket wrench 07916-KM10000
Lock nut wrench 07SMA-GBC0100
MASTER
CYLINDER
MASTER CYLINDER
14-22