FRAME/BODY PANELSiEXHAUST SYSTEM
Remove the three bolts and grab rail.
GRAB RAIL
Remove the t w o trim clips and the tw o tapping
screws.
Raise the front portion of the body cover slightly
and release it from the floor panel.
Release the front end tab o n the left body cover
f rom the right body cover, being careful not to break
it.
Pull the rear fender ribs out of the body cover.
Release the body cover from the bolt hole stud and
disconnect the 6P (white) connector.
Remove the body cover while spreading the front
portion of
it.
NOTE:
For body cover separation, refer to rear combina-
tion light rernovaVinstallation (page 20-6).
Installation is in the reverse order of removal.
2-6