Honda SH125 Manual page 201

DRIVE AND DRIVEN PULLEYSKLUTCH
~ ~~ ~~
Install the tapping screw.
Install the cable clamp and tighten the bolt.
Install the cable guide and tighten the nut.
Install a new O-ring onto the left crankcase cover.
Install the belt case air cleaner and tighten the two
bolts.
Take care not to ruin
TORQUE: 10 N-m (1.0 kgf-m, 7 Ibf-ft)
the female threads
that were made
If the left crankcase cover was replaced, tighten the
when the bolt (CT
bolt with the following torque value.
bolt) was tightened
TORQUE: 14 N-m (1.4 kgf-m, 10 Ibf.ft)
Install the following:
-
air cleaner housing (page 5-36)
-
floor lower cover (page
2-8)
first time.
DRIVE BELT
REMOVAL
Remove the following:
-
left crankcase cover (page 10-6)
-
drive pulley face (page 10-9)
-
clutch outer (page 10-12)
Remove the clutch/driven pulley assembly with the
drive belt from the drive shaft.
Remove the drive belt from the driven pulley.