Honda SH125 Manual page 200

DRIVE AND DRIVEN PULLEYSKLUTCH
-
rubberseal
-
two dowel pins
INSTALLATION
Check the rubber seal and replace it if necessary.
Clean the rubber seal groove i n the left crankcase
cover.
Install the rubber seal onto the left crankcase cover.
Install the two dowel pins into the left crankcase.
Be careful not to
Install the left crankcase cover onto the left crank-
damage the rubber
case by aligning the holes with the dowel pins.
Install the left crankcase cover bolts and tighten
seal.
them in a crisscross pattern in two or three steps to
the specified torque.
TORQUE: 10 N.m (1.0 kgf-m, 7 Ibf-ft)
Route the rear
Install the left passenger footrest and tighten the
brake cable and fuel
two bolts.
drain hose properly
(page 1-77).
10-7