Honda SH125 Manual page 298

BRAKE SYSTEM
Be careful not to
cross-thread the
adjuster.
Align the edge of
the master cylinder
with the punch
mark on the handle-
bar.
Install the joint cable into the cable holder on the
master cylinder and screw the adjuster fully.
Install the master cylinder and holder with the "UP"
mark facing up.
Tighten the upper bolt first, then tighten the lower
bolt.
TORQUE: 12 N-m (1.2 kgf-m, 9 Ibf.ft)
Rest the hose joint
pin against the
stopper.
Connect the brake hose to the master cylinder with
the oil bolt and new sealing washers.
Tighten the oil bolt.
TORQUE: 34 N-m (3.5 kgf-m, 25 Ibf-ft)
Install the setting spring into the cable holder and
connect the cable to the cable joint.
Adjust the rear brake lever and joint cable free play
(page 3-16).
Connect the brake light switch connectors.
Fill and bleed the hydraulic system (page 16-8).
Install the rear handlebar cover (page 2-1 2).
i
I
CONNECTORS
i
FRONT BRAKE CALIPER
DISASSEMBLY
Drain the brake fluid from the hydraulic system
(page 16-7).
When removing the
Disconnect the brake hose from the brake caliper by
oil bolt, cover the
removing the oil bolt and sealing washer.
the hose to
Remove the brake pads (page 16-9).
prevent contamina-
tion.