Honda SH125 Manual page 221

FINAL REDUCTION
Check the countershaft, counter gear, final gear
shaft and drive shaft for wear or damage.
BEARING REPLACEMENT
Disassemble the final reduction (page 11-6).
LEFT CRANKCASE
Becarefulnot to
Remove the drive shaft bearing if it is left in the
damage the final
crankcase.
reduction case
Remove the countershaft and final gear shaft bear-
mating surface.
ings using the special tools.
TOOLS:
Countershaft bearing:
Bearing remover set, 12
mm
07936-1660101
-
Bearing remover head, 12
mm
07936-1660110
-
Bearing remover shaft
Remover weight 07741-0010201
Bearing remover, 20
mm
07936-3710600
Bearing remover handle 07936-3710100
Remover weight 07741-0010201
07936-1 660120
Final gear shaft bearing:
Apply engine oil to new bearing cavities.
Drive the bearings into the left crankcase with the
marked side facing the attachment until
it
is fully
seated, using the special tools.
TOOLS:
Countershaft bearing:
Driver
Attachment, 37 x 40 mm
Pilot, 12 mm
Driver
Attachment, 42 x 47 mm
Pilot, 20 mm
Drive shaft bearing:
Driver
Attachment, 44 x 49.5 mm
Pilot, 22 mm
Final gear shaft bearing:
07749-0010000
07746-0010200
07746-0040200
07749-0010000
07746-0010300
07746-0040500
07749-0010000
07945-3330300
07746-0041000
11-8