Honda SH125 Manual page 257

FRONT WHEEL/SUSPENSION/STEERlNG
~~ ~~
Replace the bear-
Install the remover head into the bearing.
ings m pars Do not
From the opposite side of the wheel, install the
reuse
old
beanng
bearing remover shaft and drive the bearing out of
the wheel hub.
TOOLS:
Bearing remover head, 12 mm
Remove the distance collar and drive out the other
bearing.
Bearing remover shaft 07746-0050100
07746-0050300
ASSEMBLY
BEARING (6201 U)
GEAR
BEARING (6201 U)
BOLTS
BRAKE DISC
Pack the cavities in new bearings with grease.
Drive in the left side bearing (brake disc side)
squarely with the sealed side facing up until
it
is
fully seated.
Install the distance collar.
Drive in the right side bearing squarely with the
sealed side facing up until
it
is fully seated.
TOOLS:
Attachment, 32 x 35 mm
Driver 07749-0010000
07746-0010100
Pilot, 12 mm 07746-0040200