Honda SH125 Manual page 231

ALTERNATORISTARTER CLUTCH
INSTALLATION
Take care not to
Remove the snap ring.
damage the stator.
Remove the oil seal using the special tools.
TOOLS:
Bearing remover set, 15 mm 07936-KC10500
-
Bearing remover head, 15 mm 07936-KC10200
-
Bearing remover shaft 07936-KC10100
Remover weight 07741-0010201
Apply engine oil to a new oil seal lip.
Install the oil seal into the right crankcase cover with
the marked side facing up until it is fully seated
using the special tools.
TOOLS:
Driver
07749-0010000
Attachment, 22 x 24 mm 07746-0010800
Pilot, 14 mm 07746-0041200
Install the snap ring into the right crankcase cover
groove securely.
Install the dowel pins and a new gasket.
Remove the three bolts and water pump cover from
the right crankcase cover.
Remove the dowel pins and O-ring.
The right crankcase
Install the right crankcase cover by aligning the oil
cover (stator) is
pump shaft tab with the water pump shaft groove.
magnetically
attracted to the fly-
wheel, be careful
during ins talla tion.
Install the ground wire terminal and ten bolts, and
tighten the bolts in a crisscross pattern in 2 or 3
steps.
Install the air chamber bolts and tighten it.
12-7