Honda SH125 Manual page 342

LIGHTS/METERS/SWITCHES
Support the meter
so it does not hang
from the wire
harness.
Route the
cables,
hose and wires
properly
(page
1-1 7).
BULB REPLACEMENT
Remove the front handlebar cover (page 2-11).
Pull the bulb socket out of the meter housing.
Pull the bulb out of the socket and replace it with a
new one.
If the lower side instrument bulb will be replaced,
remove the rear handlebar cover off of the handle-
bar without disconnecting the switch connectors
(page 2-12).
Installation is i n the reverse order of removal.
REMOVAL/INSTALLATlON
Remove the following:
-
front lower cover (page 2-9)
-
front handlebar cover (page 2-1 1)
Remove the handlebar post lid by sliding it rear-
ward.
Loosen the speedometer cable joint nut (but do not
disconnect
it
yet).
Remove the rear handlebar cover (page 2-12).
Disconnect each brake light switch connectors.
Release the wire band from the rear air guide plate.
Disconnect the
6P
(white) and 9P (white) connec-
tors.
Disconnect the speedometer cable.
Release the following from the cable guide on the
handlebar post:
-
throttle cable
-
brake hose
-
speedometer cable
Release the speedometer out of the frame and
guide to remove the combination meter.
Installation is in the reverse order of removal.
TORQUE:
Cable
joint nut: 3.4 N-m (0.35 kgf-m, 2.5 Ibf-ft)