DRIVE AND DRIVEN PULLEYS/CLUTCH
MOVABLE DRIVE FACE
Check the drive face boss for wear or damage.
Measure the face bushing I.D.
SERVICE LIMIT: SH125: 24.09
mm (9.484 in)
Measure the boss O.D.
SERVICE LIMIT: SH125: 23.93
mm (0.942 in)
SH150: 24.064 mm (9.4740 in)
SH150: 23.956 mm (0.9431 in)
IN STALLATI 0 N
Clean any oil and grease from the weight rollers.
Install the weight rollers on the movable drive face.
Install the slide piece and ramp plate.
Clean any oil and grease from the drive face and the
drive belt.
Install the drive face boss into the movable drive
face assembly.
Install the movable drive face assembly onto the
crankshaft while holding the ramp plate.
Install the drive belt onto the drive face boss.
Clean any oil and grease from the drive pulley face.
Install the drive pulley face and washer.
Apply engine oil to the threads and seating surface
of the drive pulley face nut, and install the nut.
10-11
~~~