Honda SH125 Manual page 265

FRONT WHEEL/SUSPENSION/STEERlNG
Install the back-up ring.
7
Wrap vinyl tape around the fork tube top end to
avoid damaging the oil seal lip.
Apply fork fluid to a new oil seal lip. Install the oil
seal with the marking facing up.
Drive the oil seal until the stopper ring groove is vis-
ible.
TOOLS:
Driver attachment, 33 mm I.D. 07747-0010501
Fork seal driver weight 07747-0010100
Install the stopper ring into the groove in the fork
slider, being careful not to scratch the fork tube slid-
ing surface.
Coat the lips of a new dust seal with fork fluid and
install it.
Pour the specified amount of the recommended fork
fluid into the fork tube.
RECOMMENDED FORK FLUID:
Honda Ultra Cushion Oil 1OW or equivalent
100 f 1 cm3 (3.4 f 0.03 US 0 ~ 3 . 5
f
0.04 Imp
0 2 )
Slowly pump the fork tube several times to remove
any trapped air from the lower portion of the fork
tube.
Compress the fork tube fully. Measure the fluid level
from the top of the fork tube.
FLUID LEVEL: 106 mm (4.2 in)
Pull the fork tube up and install the fork spring with
the tightly wound coil side facing down.
FLUID CAPACITY
I
DUSTSEAL
1 1
...
- .
67mm