FRONT WHEEL/SUSPENSION/STEERING
HANDLEBAR
REMOVAL
Remove the combination meter (page
20-8).
Loosen the brake joint cable lock nut and screw the
adjuster fully.
Disconnect the joint cable from the cable joint on
the brake arm and remove the setting spring.
Keep the reservoir
Remove the two bolts and master cylinder holder,
upright to prevent
and the brake master cylinder off of the handlebar.
air from entering
Remove the joint cable from the cable holder on the
master cylinder by turning the adjuster.
the hydraulic sys-
tem.
Remove the following:
- two
screws
-
upper throttle housing
-
throttle cable (disconnect by turning the throttle
grip)
-
lower throttle housing
-
throttle grip