Honda SH125 Manual page 339

LIGHTS/METERS/SWITCHES
FRONT TURN SIGNAL/POSITION
LIGHT
BULB REPLACEMENT
TURN SIGNAL BULB
Remove the bulb socket by turning it counterclock-
wise.
Remove the socket/bulb out of the front lower
cover, being careful not to damage the its wire.
While pushing the bulb in, turn it counterclockwise
t o remove
it,
and replace
it
with a new one.
Check the rubber seal is in good condition and
replace it with a new one if necessary.
Installation is i n the reverse order of removal.
POSITION LIGHT BULB
Pull the bulb socket out of the light housing.
Remove the socket/bulb out
of
the front lower
cover, being careful not t o damage the its wire.
Pull the bulb out of the socket and replace it with a
new one.
Installation is i n the reverse order of removal.
REMOVAL/ IN STA LLATl ON
Remove the front lower cover (page 2-9).
Release the wires from the wire guide.
Remove the three screws and turn signal/position
light assembly.
Route the wires
Installation is i n the reverse order of removal.
properly
(page
1-17).