FRONT WHEEL/SUSPENSION/STEERlNG
Clean the inside surface of the left handlebar grip
and the outside surface of the handlebar.
Apply Honda Bond A or equivalent to the inside sur-
face of the handlebar grip and to the outside surface
of the handlebar.
~ l l o w t h e a d h e s i v e
Wait 3
-
5 minutes and install the grip. Rotate the
to dry for
I
hour
grip for even application of the adhesive.
before using.
Install the brake lever bracket by aligning the locat-
ing pin with the hole in the handlebar, and secure
it
with the holder and washer-bolt. Tighten the bolt
securely.
Clean the sliding surfaces of the throttle grip pipe
and handlebar.
Install the throttle grip onto the handlebar.
Apply grease to the throttle grip flange groove.
Connect the throttle cable to the throttle grip flange
and set the lower throttle housing by aligning the
locating pin with the hole in the handlebar.
Install the upper throttle housing and tighten the
two screws securely.
14-21