Honda SH125 Manual page 300

BRAKE SYSTEM
ASSEMBLY
CALIPER BRACKET
\
PIN BOOT B
PIN
PAD SPRING
BRAKE PADS
Coat n e w piston and dust seals with clean brake
fluid and install them into the seal grooves in the
caliper.
Coat the caliper pistons with clean brake fluid and
install them into the caliper cylinder with the open
side toward the pads.
Check the pin boots and replace them if they are
hard, deteriorated or damaged.
Apply silicone grease to the insides of the boots.
Install the boot into the caliper body.
Install the pad spring in the direction as shown.
Install the pad retainer with adhesive Honda Bond A
or equivalent if
it
was removed.
Install the caliper bracket over the caliper body.
Make sure the boot ribs are seated into the boot
grooves in the bracket pins properly.