Honda SH125 Manual page 305

BRAKE SYSTEM
-
locklever
-
return spring
-
equalizer joint screw
-
lever pivot nut
-
pivot screw
-
rear brake lever
Loosen the adjusting nut and disconnect the rear
brake cable (page 3-16).
Disconnect the joint cable from the master cylinder
(page 16-11).
Be careful not to
Remove the following:
damage the cable
-
link rod boot
endboots.
-
rear brake cable
-
jointcable
-
equalizer link
For lever bracket removal and installation, refer to
page 14-19 "Handlebar".
INS P ECTlO N
Check the link arm and rod for wear, deformation or
damage.
Check the boot for wear, deterioration or damage.
ASSEMBLY
NOTE:
Do
not exchange the rear brake cable and joint
cable.
Route the cables properly (page 1-17).
Apply grease to the link sliding area.
Place the equalizer link into the equalizer housing of
the lever bracket through the link rod hole in the
direction as shown.
Install the joint
Connect the cables to the link arm and install them
cable
first, then the
into the housing.
cable.
Install the boot onto the link rod, and set the boot
ribs into the groove in the rod and into the groove in
the housing.