Honda SH125 Manual page 299

BRAKE SYSTEM
~-
-
caliper bracket
-
padspring
-
boots
Place a shop towel over the piston.
~ o n o t u s e h i g h
Position the caliper body with the piston facing
pressureairorbring
down and apply small amounts of air pressure to
the nozzle too close
the fluid inlet t o remove the piston.
to the inlet.
Be careful not to
Push the dust and Diston seals in and lift them out.
Clean the seal grooves, caliper cylinder and piston
with clean brake fluid.
damage the piston
sliding surface.
INSPECTION
Check the caliper cylinder and piston for scoring,
scratches or damage.
Measure the caliper cylinder I.D.
SERVICE LIMIT: 27.06 mm (1.065 in)
Measure the caliper piston O.D.
SERVICE LIMIT: 26.91 mm (1.059in)
16-16