Honda SH125 Manual page 125

FUEL SYSTEM (Proarammed Fuel Iniection)
3. Turn the ignition switch to OFF.
Remove the bank angle sensor (page 5-46).
Connect the 3P connector.
4. Measure the voltage between the Redlorange
wire terminal (+) and Green wire terminal (-) of
the 3P connector.
Place the bank angle sensor horizontal and turn
the ignition switch to ON.
There should be 0 - 1 V.
Angle the sensor approximately 60 degrees to
the left or right with the ignition switch to ON.
There should be battery voltage.
NOTE:
If you repeat this test, first turn the ignition
switch to OFF, then back to ON before you try the
test again.
REMOVAL/INSTALLATION
Remove the frame body cover (page 2-5).
Remove the three bolts and frame bracket.
Remove the two screws.
Disconnect the 3P connector to remove the bank
angle sensor.
Installation is in the reverse order of removal.
TORQUE: Screw: 1.2 N.m (0.12 kgfam, 0.9 Ibf.ft)
Green Redlorange
(Viewed from the harness side)
Horizontal
position
60"
f..