BATTERY/CHARGING SYSTEM
BATTERY
REMOVAL/I NSTALLATIO N
Always turn the
Remove the maintenance lid (page 2-4).
Remove the two screws and battery setting plate.
ignition switch OFF
before removing
the battery.
Remove screw and disconnect the negative
(-1
cable.
Remove screw and disconnect the positive (+) cable
and remove the battery.
Connect the posi-
Install the battery i n the reverse order of removal.
(+)
cab'e first
After installing the battery, coat the terminals with
then connect the
negative
(--)
cable.
clean grease.
VOLTAGE INSPECTION
Remove the maintenance lid (page 2-4).
Measure the battery voltage using a commercially
available digital multimeter.
VOLTAGE (2OoC/68"F):
Fully charged:
13.0
-
1 3 . N
Under charged: Below 12.3V
BATTERY CHARGING
Remove the battery (page 17-6).
Turn power O N / O f f
Connect the charger positive (+) cable to the battery
at the charger, not
positive
(+)
terminal.
at the battery termi-
Connect the charger negative
(-)
cable to the battery
na/.
negative
(-1
terminal.
CHARGING CURRENT/TIME:
Standard:
0.6 A15 - 10 h
Quick:
3 A l l h
Quick-charging should only be done i n an emer-
gency; slow charging is preferred.
For battery charging, do not exceed the charging
current and time specified on the battery. Using
excessive current or extending the charging time
may damage the battery.
BATTERY
I