BRAKE SYSTEM
Install the boot into the master cylinder and piston
groove.
Apply silicone grease to the brake lever contacting
surface of the piston.
Apply silicone grease to the brake lever and arm
pivots.
Hook
the spring
Set the brake lever and arm into the master cylinder
long end into the
and install the pivot bolt with the spring.
hole in the leverand
Tighten the pivot bolt.
TORQUE: 1.0 N-m (0.1 kgf-m, 0.7 Ibf.ft)
the short end
against the master
cylinder body.
Install the pivot nut and tighten
it.
TORQUE: 6 N.m (0.6 kgf-m, 4.4 Ibf-ft)
Install the brake light switch, aligning the locating
pin with the hole, and tighten the screw.
TORQUE: 1.2 N-m (0.12 kgf-m, 0.9 Ibf-ft)