LIGHTS/METERS/SWITCHES
REMOVAL/INSTALLATION
Remove the radiator (page 6-17).
Release the following and remove the rear air guide
plate.
-
ignition switch wire (from the wire guide)
-
two wire bands
Remove the switch cap by turning
it
counterclock-
wise.
Disconnect the ignition switch 2P (white) connector.
Remove the rubber sheet from the ignition switch,
being careful not to damage it.
Loosen the cable joint nut and disconnect the seat
lock cable from the ignition switch.
Remove the two bolts and ignition switch.
Install the ignition switch with new switch bolts and
tighten them securely.
Route the
wires
Install the removed parts in the reverse order of
lpage
7-77).
Install the radiator (page 6-17)
and cable properly
removal.