REAR WHEEL/SUSPENSION
Install the snap ring into the swingarm groove
securely with the chamfered side facing the bearing.
Apply grease to the lips of new dust seals.
Install each dust seal until it is flush with the swing-
arm.
BEARING INSPECTION/
REPLACEMENT
Remove dust seals from the both sides of the swin-
garm.
SNAP RING
Remove the snap ring.
Turn the inner race of the bearing with your finger;
the bearing should turn smoothly and quietly. Also
check that the bearing outer race fits tightly in the
swing arm.
Replace the bearing if the inner race does not turn
smoothly and quietly, or
if
the outer race fits
loosely.
Drive the bearing out of the swingarm.
Drive in a new bearing squarely until
it
is fully
seated.
TOOLS:
Attachment, 42 x 47 mm
Driver
07749-0010000
07746-0010300
Pilot, 17 mm
07746-0040400
15-6