Honda SH125 Manual page 110

FUEL SYSTEM (Programmed Fuel Injection)
FUEL LINE INSPECTION
QU ICK-CON N ECT FlTTl N G
PRESSURE RELIEVING/REMOVAL
NOTE:
To disconnect the fuel feed hose, relieve pres-
sure from the system as follows.
Remove the luggage box (page 2-5).
1. Disconnect the fuel pump 5P (white) connector
with the ignition switch turned to OFF.
2. Start the engine and let it idle until the engine is
stall.
Turn the ignition switch to OFF.
3.
Remove the fuel fill cap t o relieve fuel pressure
from the fuel tank.
Install the fuel fill cap.
Cleanaroundthe
4. Release the feed hose from the clip on the fuel
quick-connect fit-
pump retaining plate.
ting before discon-
Take the rubber seal off of the hose joint.
necting the hose,
and be sure that no
dirt
IS
allowed to
enter into the fuel
system
Prevent the remain-
5. Place a shop towel over the quick-connect fitting.
ing fuelin the hose
Hold the connector with one hand and press
from flowing out
down the retainer tabs with the other hand, then
with a shop towel.
pull the connector off.
NOTE:
Be careful not t o damage the joint retainer or
other parts. Do not use tools.
If the connector does not move, keep the retainer
tabs pressed down, and alternately pull and push
the connector until it comes off easily.
FUEL FILL CAP
RUBBER
I
SEAL
HOSE JOINT
TABS
CONNECTOR
R ETA1 N
E
R
5-3 1