Honda SH125 Manual page 202

Check the drive belt for cracks, separation or abnor-
mal or excessive wear.
Measure the drive belt width.
INSTALLATION
Clean any oil and grease from the driven faces.
Spread the driven pulley width by compressing the
driven face spring while turning the movable driven
face clockwise, and install the drive belt into the
driven pulley.
DRIVE BELT
\
Jake care not to get
Install the clutch/driven pulley assembly onto the
grease of the driven
drive shaft, and the drive belt onto the drive face
face inner surface
boss.
Install the following:
drive
-
clutch outer (page 10-20)
shaft.
-
drive pulley face (page 10-11)
to the splines and
Of
-
left crankcase cover (page 10-7)
DRIVE PULLEY
REMOVAL
Remove the left crankcase cover (page 10-6).
Hold the drive pulley face with special tool and
loosen the drive pulley face nut.
TOOL:
Universal holder 07725-0030000
Remove the nut, washer and drive pulley face.
10-9