Honda SH125 Manual page 251

FRONT WHEEL/SUSPENSION/STEERlNG
ITEM STANDARD
Minimum tire tread depth
-
Cold tire Driver only
175 kPa (1.75 kgf/cm2, 25 psi)
pressure Driver and passenger 175 kPa (1.75 kgf/cm2, 25 psi)
Axle runout
-
Wheel rim Radial
-
runout Axial
-
Wheel balance weight
-
Fork Spring free length 257.2 (10.13)
Tube runout
-
Recommended fork fluid
Fluid level 106 (4.2)
Fluid capacity
Honda Ultra Cushion Oil 1OW
or equivalent
100 f 1 cm3 (3.4 f 0.03 US
02,
3.5 f 0.04
ImD
02)
SERVICE INFORMATION
GENERAL
Raise the front wheel off the ground by supporting the frame securely when servicing the front wheel, suspension and
steering stem. A hoist or equivalent is required to support the scooter.
A contaminated brake disc or pad reduces stopping power. Discard contaminated pads and clean a contaminated disc
with a high quality brake degreasing agent.
After installing the front wheel, check the brake operation by applying the front brake lever.
Use only tires marked "TUBELESS" and tubeless valves on rim marked "TUBELESS TIRE APPLICABLE".
Refer to page 16-2 for brake system service.
Refer to page 20-14 for handlebar switch inspection.
SERVICE LIMIT
1.5
(0.06)
-
-
0.2 (0.01
1
2.0 (0.08)
2.0 (0.08)
70 g (2.50~)
max.
252 (9.9)
0.2 (0.01
-
-
-
SPECIFICATIONS
TORQUE VALUES
Steering stem lock nut
Steering bearing upper inner race
Fork socket bolt
Handlebar post nut
Master cylinder holder bolt
Brake disc bolt
Front axle nut
Speedometer cable setting screw
Caliper mounting bolt
68 N.m (6.9 kgf.m, 50 Ibf.ft)
See page 14-26
20 N.m (2.0 kgf.m, 15 Ibf.ft) Apply locking agent to the threads.
39 N.m (4.0 kgf.m, 29 Ibf.f&) U-nut.
12 N.m (1.2 kgf.m, 9 Ibf.ft)
42 N.m (4.3 kgf.m, 31 1bf.h) ALOC bolt: replace with a new one.
68 N.m (6.9 kgfem, 50 Ibf.ft) U-nut.
2.2 N.m (0.22 kgf.m, 1.6 Ibf.ft)
30 N.m (3.1 kgf.m, 22 Ibf.ft) ALOC bolt: replace with a new one.