Cos Queue Configuration; Show Classofservice Trust - NETGEAR GSM7228PS Software Administration Manual

CoS Queue Configuration

CoS queue configuration involves port egress queue configuration and drop precedence
configuration (per queue). The design of these on a per-queue, pe- drop precedence basis
allows you to create the service characteristics that you want for different types of traffic.
Port egress queue configuration:
• Scheduler type, strict vs. weighted
• Minimum guaranteed bandwidth
• Maximum allowed bandwidth per-queue shaping
• Queue management type, tail drop vs. WRED
Drop precedence configuration (per queue):
• WRED parameters
- Minimum threshold
- Maximum threshold
- Drop probability
- Scale factor
• Tail drop parameters, threshold
Per-interface basis:
• Queue management type, rail Drop vs. WRED
Only if per-queue configuration is not supported
• WRED decay exponent
• Traffic shaping for an entire interface

Show classofservice Trust

The example is shown as CLI commands and as a Web interface procedure.
CLI: Show classofservice Trust
To use the CLI to show CoS trust mode, use these commands:
(Netgear Switch) #show classofservice trust?
<cr> Press Enter to execute the command.
(Netgear Switch) #show classofservice trust
Class of Service Trust Mode: Dot1P
166 | Chapter 11. CoS Queuing
ProSafe 7000 Managed Switch Release 8.0.3