Reset; Upload; Device Reboot; Factory Default - NETGEAR XS728T ProSAFE Software Administration Manual

Reset

The Reset menu contains links that provide access to the features described in the following
sections:
•

Device Reboot

•

Factory Default

Device Reboot
Use the Device Reboot screen to reboot the switch.
To reboot the switch:

1. Select Maintenance > Reset > Device Reboot.
Select the check box.
2. Click Apply.
The switch resets immediately.
The management interface is not available until the switch completes the boot cycle. After the
switch resets, the login screen appears.
Factory Default
Use the Factory Default screen to reset the system configuration to the factory default values.
Note: If you reset the switch to the default configuration, the IP address is
reset to 192.168.0.239, and the DHCP client is enabled. If you loose
network connectivity after you reset the switch to the factory defaults,
see Connect the Switch to the Network
To reset the switch to the factory default settings:

1. Select Maintenance > Reset > Factory Default.
2. Select the check box.
3. Click Apply.
The switch resets immediately.

Upload

The switch supports system file uploads from the switch to a remote system by using either
TFTP or HTTP.
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
Maintenance
on page 6.
164