Reference Guide for the Model RT338 ISDN Router
Verifying Power
After connecting the power adapter to the router and a power source, complete the following steps
to verify that power is correctly applied to the router:
Switch the POWER switch to ON.
1.
Verify that the PWR LED is lit.
2.
Verify that the TEST LED begins to blink within a few seconds.
3.
After approximately 30 seconds, verify that:
4.
The TEST LED turns off.
a.
The LNK/ACT LED is lit.
b.
If the LNK/ACT LED is lit, the router has established a link to the Ethernet network.
If the LOCAL port is connected to a 100 Mbps device, verify that the 100 LED is lit.
5.
You are now ready to begin configuration of your network, as described in
Your
Network."
2-8
Chapter 3, "Preparing
Installing and Connecting the Router